Start Up 8
________________________________________________________________________________________
_______________________________________
8-5
Press the General Set screen button (819). Each of the axes will move slowly in a negative
direction until they reach the zero switch for each axis. Upon reaching the appropriate zero limit
switch, the axis will move slowly forward until it just comes off it’s switch. This is the trigger point
for setting the axis.
If the machine General Set message will not clear, it is because one or more of the axes
has not set. Check for obstructions. Refer section 11 Trouble shooting.
It is possible to view the drive controls in the Troubleshooting page.
Access to this information is via the troubleshooting icon (831) on the home page.
Viewing the 3 axis outputs on this troubleshooting page shows which axes are moving (or trying to
move). If an axis is blocked from reaching it’s limit switch, it will continue to show a drive speed
value in these positions (832). This obstruction or faulty switch needs to be cleared.
When the General Reset is completed, the machine is now ready to run.
832
To Next Page
Loading...