Run 9
________________________________________________________________________________________
_______________________________________
9-33
When LENGTH CUT “OFF” is selected, the butt join sensing arm (938) swings out and
remains out (though it will retract automatically when the convex sensor is off) running
along the edge of the panel feeling for the sensing cam (966) on the finishing pod.
This sensing trigger (966) is a plastic screw which screws into the M6 hole in the
FINISHING BLOCK. When the butt join sensor switch (934) contacts this cam, the feed
stops, edge tape is cut and then the head continues laying the edge material and trims
until the trimmer and scraper run off the workpiece.
950
953
954
953
966
938
934
To Next Page
Loading...