Veeder-Root TLS-450PLUS - ISD Alarm Summary

58
Operations Alarms
ISD ALARM SUMMARY
Table 4 summarizes the ISD Alarms.
Alarms with footnote 2 will result in a site shutdown.
Table 4: ISD Alarm Summary
Displayed Message
ISD
Monitoring
Category
Light
Indicator Description
Suggested Troubleshoot-
ing
1
ISD VAPOR LEAK WARN Containment Yellow Vapor Leakage Detection
test warning
• Exhibit 7 Nozzle Bag Test
• Exhibit 9/10 Operability Test
• T.P. 201.1E-PVV Test
• Exhibit 4 Clean Air Separator
Test
• TP-201.3
ISD VAPOR LEAK FAIL
2
Containment Red Vapor Leakage Detection
test - 8th consecutive fail-
ure
ISD GROSS PRESS WARN Containment Yellow Gross Over Pressure test
warning
• Are ball valves for the clean air
separator in the correct
position?
• Is the ball valve near the
pressure sensor in the correct
position?
• Exhibit 7 Bag Test
• T.P. 201.1E-PVV Test
ISD GROSS PRESS FAIL
2
Containment Red 8th Consecutive Failure of
Gross Containment Pres-
sure Test
ISD DEGRD PRESS WARN Containment Yellow Degradation Over-Pres-
sure test warning
ISD DEGRD PRESS FAIL
2
Containment Red Degradation Over-Pres-
sure test - 30th consecu-
tive failure
• T.P. 201.3
• Look for problems using one
or more of the following VR-
202 procedures/tests: Dis-
penser Integrity Test B-3 (i.e.
'Pumbing Tightness' test),
Exhibit 4, Exhibit 5, Exhibit 9
(pressure sensor only) or Flow
Rate Verification per section
1.2.3.
ISD VP STATUS WARN Processor Yellow Failure of Vapor Proces-
sor Effluent Emissions or
Duty Cycle test
• Troubleshooting Guide
• VP Emissions Test
ISD VP STATUS FAIL
2
Processor Red 2nd Consecutive Failure
of Vapor Processor Status
test
VP EMISSION WARN
3
Processor Yellow Mass emission exceeded
the certified threshold
• Troubleshooting Guide
• Exhibit 11
VP EMISSION FAIL
3
Processor Red 2nd Consecutive Mass
Emission test failure
PMC SETUP FAIL Self-Test Red PMC is not configured or
missing components
• See ISD Toubleshooting
Guide P/N 577014-463
PMC SENSOR FAULT Self-Test Red Component used by PMC
has failed or reported an
error condition.
• Check for Sensor Device
alarm or fault.
• See ISD Toubleshooting
Guide P/N 577014-463