Veeder-Root TLS2 - Page 4

Table of Contents
iv
Overfill Alarm Relay ....................................................................................................32
Applying Power to System
Cold Boot ........................................................................................................................33
Warm Boot ......................................................................................................................34
Communications
RS-232 Peripheral Equipment Requirements .................................................................35
RS-232 Connections .......................................................................................................35
To a Device Less Than 50 Feet (15 Metres) from the Console..............................35
To a Device More Than 50 Feet from the Console ................................................35
Surge Protection for Communication Devices ................................................................35
DB-9 Connector Pin-Outs ...............................................................................................37
Comm Port 2 Pin-Outs ....................................................................................................37
Figures
Figure 1. Control Drawing - Example TLS2/EMC2 System Site Layout ...................3
Figure 2. Console Dimensions and Designated Wiring Entry Knockouts .................7
Figure 3. Recommended Mounting of Console - International Installations .............8
Figure 4. Recommended Mounting of Console - Alternate Installations ..................9
Figure 5. Wiring AC Power to the Console .............................................................11
Figure 6. CPU Board Components .........................................................................12
Figure 7. Calculating the Correct Mag Probe Length for dedicated
riser installation .......................................................................................13
Figure 8. Mag Probe AST Installation Kit ...............................................................14
Figure 9. Cap and Cord Grip Kit .............................................................................15
Figure 10. Metal Cap and Ring Kit ...........................................................................16
Figure 11. Modifying an Existing Metal Riser Cap ....................................................17
Figure 12. Installing Probe Canister Spacer Rings for 3- & 4-inch Risers ................19
Figure 13. Installing Insulating Sleeves for 2-inch Risers .........................................20
Figure 14. Probe Float/Boot Installation ...................................................................21
Figure 15. Probe Installation Example - Underground Storage Tank .......................23
Figure 16. U.S. Probe Installation Example - Above Ground Storage Tank .............24
Figure 17. Installing the Riser Adaptor .....................................................................25
Figure 18. Example Probe Wiring Run in Buried Rigid Conduit ...............................26
Figure 19. Example Probe Wiring Run Using the Direct Burial Method ...................27
Figure 20. Probe Field Wiring Connection ................................................................28
Figure 21. Epoxy Sealing Connections ....................................................................29
Figure 22. Connecting Probe Wiring to Console ......................................................31
Figure 23. Connecting Output Relay to Console ......................................................32
Figure 24. RAM Clear Jumper Positions ..................................................................33
Figure 25. Cold boot ‘No Tanks Configured’ message .............................................34
Figure 26. Example of Console Connected to a Remote Device Via
MDE800A Short-Haul Modems ...............................................................36
Tables
Table 1. Mag Probe AST installation kit - Part No. 312020-984 ............................14
Table 2. Cap and cord grip kit - Part No. 330020-282 ...........................................15
Table 3. Metal Cap and Ring Kit - Part No. 312020-952 .......................................16
Table 4. TLS2/EMC2 DB-9 Pin-Outs .....................................................................37
Table 5. Comm Port 2 Configuration .....................................................................37