Vega VEGAPOINT 21 - Parameter Adjustment

24
7 Setup
VEGAPOINT 21 • Transistor (NPN/PNP)
56623-EN-210210
Menu item Function Default value
Status Device status
Status outputs
Parametermodicationcounter
OK
OK
Quantity
Peak value indicator Pointer function resonance frequency
Pointer function measuring cell temper-
ature
Peak values, electronic temperature
-
-
-
Measured values Menu item -
Simulation Menu item -
Impedance curve Menu item -
Sensor information Menu item -
Sensor characteristics
6)
Menu item -
7.4 Parameter adjustment
7.4.1 Main menu
Here you can assign a suitable measurement loop name.
This name is stored in the sensor and is used to identify the device.
You can enter names with max. 19 characters. The character set
comprises:
•
Upper and lower case letters from A … Z
•
Numbers from 0 … 9
•
Special characters and blanks
In this menu item you can select the application. You can choose from
the following applications:
•
Standard (level detection)
•
User-dened
Note:
Theselectionoftheapplicationhasaconsiderableinuenceonall
other menu items. Keep in mind that as you continue with the param-
eter adjustment, individual menu items are only optionally available.
Standard (level detection)
•
Uncovered
•
Covered
•
With buildup
User-dened
If you have selected the application User-dened you can adjust the
switching states with the original medium or with the actual covering
state.
Diagnostics
Measurement loop name
(TAG)
Application
6)
Only DTM adjustment