Vega VEGAPULS 21 - Setup with PC;notebook (VEGACONNECT); Connecting the PC via signal cable

28
9 Setup with PC/notebook (VEGACONNECT)
VEGAPULS 21 • Two-wire 4 … 20 mA/HART
58351-EN-191014
9 Setup with PC/notebook (VEGACONNECT)
9.1 Connect the PC
1
2 4
3
5
OPEN
TWIST
USB
LOCK
Fig. 23: Connecting the PC to the signal cable
1 Sensor
2 HARTresistance250Ω(optionaldependingonevaluation)
3 Connection cable with 2 mm pins and terminals
4 Processing system/PLC/Voltage supply
5 Interface adapter VEGACONNECT
Note:
With power supply units with integrated HART resistance (internal
resistanceapprox.250Ω),anadditionalexternalresistanceisnot
necessary. This applies, e.g. to the VEGA instruments VEGATRENN
149A, VEGAMET 381, VEGAMET 391. Common Ex separators are
alsousuallyequippedwithasucientcurrentlimitingresistance.In
such cases, the interface converter can be connected parallel to the
4 … 20 mA cable (dashed line in the previous illustration).
Via interface adapter to
the signal cable