Start Mode
Start mode combines a timer and perpendicular distance to line display to provide the information
necessary for a perfect start at the gun.
The semi-circles next to the PIN and RC buttons indicate if the respective ends are set. When both ends
are set a line appears between them to illustrate that the line is set.
Timer
The count-down timer displayed as mm:ss. The timer can be set from 1:00 to 15:00.
Distance To Line
‘Distance To Line’ is the perpendicular distance to the user defined line. Refer to Set Start Line on page
20 for detailed information on setting the start line. ‘Distance To Line’ is displayed in meters.
A negative ‘Distance To Line’ means that the boat is over the line. Three hyphens ‘---’ are displayed when
the line is not defined and a GPS signal is available. When the ‘Distance To Line’ is larger than 1000
meters ‘>999’ is displayed.
‘Distance To Line’ can be displayed with either 0.1m or 1m resolution. Refer to ‘Setting Distance to Line
Precision’ on page 28 of the Configuration section
To Next Page
Loading...
