Three resources for finding your Local Magnetic Declination
• Enter http://www.magnetic-declination.com/ into your web browser
• Enter https://www.ngdc.noaa.gov/geomag/calculators/magcalc.shtml into your web browser
• Search “magnetic declination calculator” in the search engine of your choice
Press GUN button to save your selection and progress to the next menu, or press RESET to exit config
without saving the current menu (all previous menus will still have been saved).
Setting Bow Offset
Options: [ 0m to +12.5m ] Default: 0m
The sixth config menu selects a bow offset. The default is 0m.
You will see ‘b OFFSEt’ scrolling across the bottom display and some distance from 0 (default), to 12.5m
on the top display. Pressing the RC button will increase the bow offset by 0.1m and PIN button will
decrease it by 0.1m. You can also hold either the PIN or RC button for larger changes.
Bow offset is the distance in meters from where the ProStart is mounted to the bow of your boat. In
start mode the offset is used to calculate the distance between the tip of your bow and the start line.
For more information on setting the line with and without the bow offset see Understanding Distance to
Start Line section on page 31.
Press GUN button to save your selection and progress to the next menu, or press RESET to exit config
without saving the current menu (all previous menus will still have been saved).
Setting Distance to Line Precision
Options: [ 0.0 | 0 ] Default: 0.0
The seventh config menu selects a precision level for the distance to line feature. The default is one
decimal place (0.0)
You will see ‘diStAncE PrEciSion’ scrolling across the top display and either ‘0.0’ (default), or ‘0’ on the
bottom display. Pressing the RC or PIN button will toggle between “0.0” and ‘0’.
When 0.0 is selected the distance to line will display in increments of 0.1m when the start line is set and
the ProStart is in Start Mode. Alternatively, when 0 is selected the distance will display in increments of
1m.
Press GUN button to save your selection and progress to the next menu, or press RESET to exit config
without saving the current menu (all previous menus will still have been saved).
To Next Page
Loading...
