Selecting Bonus Screen Top and Bottom Metrics
Top Display Options: [ Mag Heading | COG | SOG | Heel | Pitch | Shift ] Default: Mag Heading
Bottom Display Options: [ Mag Heading | COG | SOG | Heel | Pitch | Shift ] Default: COG
The tenth config menu is only accessible if ‘On’ was selected on the previous config menu page -
‘Enabling Bonus Screen.’ This config menu will let you select which metrics you want displayed on the
bonus screen. The default metrics are: Heading on the top display, COG on the bottom display, and Heel
on the bar graph.
First you will set the Top Metric as shown by it scrolling across the screen. Progress through the various
metrics available by pressing either the PIN or RC button. Once you have found the metric you want for
the top display press the GUN Button to save it and move on to selecting the bottom metric.
You will now see the bottom display scrolling across the screen. Select the bottom metric just as you did
for the top metric. Once you have selected your desired metric for the bottom display and pressed GUN
button to save it you will be taken to the ‘Selecting Bonus Screen Bar Graph Metric,’ menu.
In order to return to setting the top metric once again you will need to exit the Config Menu and re-enter
it, scrolling through all the option until you return to this menu item.
Selecting Bonus Screen Bar Graph Metric
Options: [ Heel | Shift | Off ] Default: Heel
The eleventh config menu is only accessible if ‘On’ was selected on the ‘Enabling Bonus Screen,’ menu.
This config menu will let you select which metric you want displayed on the bonus screen. Bar graph. The
default is Heel angle.
Bonus Mode Bar Graph setting page where again you can scroll through your options with the PIN or RC
Buttons.
Zeroing Pitch and Heel Angles
In order to zero Pitch and Heel angles for your mounted ProStart you must first ensure that HEEL (not
shift) is being displayed while in RACE mode. (see Setting Race Bar Graph section to switch between shift
and heel). Now, while in Race Mode a single short press of the reset button will zero both the heel and
pitch angles to the exact orientation of the ProStart unit in that moment.
To Next Page
Loading...
