6 General specifications and instructions
6.1 Be aware
A. Always make sure the system is delivered with the right certificate, warning
stickers and documentation!. Do not remove the original sticker(s)!!
B. Make sure the validation time of the certificate is never exceeded!
C. Never remove safety instructions of the Blade!
D. All Verdegro Truck Mounted Attenuators (BLADE TMA) shall be designed and
manufactured by the BLADE BV, in accordance with the specifications.
E. The Verdegro Blade is an attenuator system designed for installation at the back
of trucks with gross vehicle weight (GVW) ranges between minimum weight of
16.010 lbs. (7.262 kg )and a maximum weight of
22.120lb (10.033 kg)
(Contact
the Verdegro Group for other specifications!).
Note: Any added ballast must be adequately anchored to the truck so that it will
not move during impacts. Make sure the manufacturer’s published maximum axle
loads will never be exceeded, because the back end of the truck supports the
weight of the rearward protruding Blade. To ensure the driving characteristics of
the vehicle are maintained, the manufacturer's recommended center-of-gravity
zone should also be adhered to.
To Next Page
Loading...