VERDEGRO Blade - Maintenance Schedule and Details; Checking Hydraulic Oil

Page 58 of 68
Operation and maintenance manual Verdegro Blade
13 Maintenance
Scheduled maintenance keeps the Blade in safe and reliable condition. From the
maintenance schedule and checklist for the annual inspection shows what measurements
are required. Read for the maintenance of the Blade the entire manual carefully!. If in
doubt about the maintenance work, it is better that it is carried out by the manufacturer.
If not, than it must be done under supervision of the manufacturer, for example by an
official distributor. Distributors can be found on the website www.verdegro.com /
www.Blade-tma.com
13.1 Checking hydraulic oil
The Blade has an oil level in the tank.
• Open the hydraulic compartment
• Make sure the machine is reasonably flat
• Before opening the cap or around the filling is clean, clean it if necessary.
• Add the oil with a special pump with filter. The use of the oil directly from the can
to pour.
13.2 Service schedule
Term
Actions
Daily or before
any start up
Check level Hydraulic oil
Check bearings parts
Check hydraulic hoses and cylinders, pipes and fitting
Check operation of emergency and safety devices
Piston rods outrigger daily check for debris, leaks or damage. If
severely polluted or clean brine is presents.
Try all in normal position
Each 500 hours or
at latest each
month
Lubricate all bearings and sliding surfaces
Turntable bolts tightened
Level device bolts tightened
Check condition of cylinders and outrigger
Each 1000 h of
latest 6 months
Check of total Blade
Every 12 months
Annual inspection. + Full service preventive replacement valves
and seals.
Cushion
Check daily for damages
Table 4