14
EN
Alternative taste card order
Left taste card Right taste card
Espresso Cappuccino
Coffee Latte Macchiato
Cafe Americano Cafè latte
Double espresso
Jug Hot water
Procedure for changing the configuration:
1. Open the door with key and go to the rinse menu.
2. Scroll down to ‘password’ then press start.
3. Enter the password as ‘22222’ with the help of down scroll key, it will enable the factory menu.
4. Select ‘load defaults’, it will ask you ‘
Defaults will overwrite all settings!” and counters will be
reset are you sure?”. Select start to accept. Machine will restart.
5.
After machine restarts, it will show the machine types. Select your machine type as Minibar
Espresso.
6.
It will ask you configuration type, select the required configuartion as config 1 or config 2.
Before changing the machine configuration from software, make sure that your canister type and content
is per the new configuration. Refer above tables for canister contains for the specific configuration.
Modification of the cacao canister to a sugar canister can be done by simply removing the agitator wheel.
Other types of product than mentioned above can require a new canister type or conversion kit. The
software has no extra configurations for those special canister/products. They can be used, but settings
have to changed manually in the Product settings in the Service menu. However, after doing that, the
settings can be saved to USB flash disk to save for later use.
3.7.3 Taste card installation
a.
b.
c.
d.
e.
/3.4
To Next Page
Loading...