27
EN
6.6 Daily maintenance
For cleaning you may only use water, possibly with some dishwashing detergent. Always rinse
thoroughly with clean water.
The machine is pre-installed with an automated daily rinsing option enabled each early morning.
When active, it will ask to place a canister underneath the outlet and press start to start rinsing. When
not active, it should be done manually. Full daily maintenance consists off:
1 Open the door of the machine to activate the Rinse menu.
2 Check the container spouts for stuck product. If so remove and clean them (dry).
3 Remove the waste bucket, empty it and place back in the machine.
4 Place a canister or similar underneath the outlet.
5 Check for possible leakage during rinsing.
6 Rinse the brewer by selecting the function ’Daily rinsing’ and then ‘Rinse brewer’.
! WARNING: hot water!
7 Rinse the mixing systems by selecting the function ‘Rinse all mixers’.
8 Repeat this rinsing once.
9 Turn the machine off with the mains switch.
10 Carefully remove the drip tray from the machine and remove the grill. Empty the drip tray and
clean tray and grill with lukewarm water and a brush. The drip tray may not be placed in the
dishwasher because that may damage the finish.
11 Remove the waste bucket and empty it.
12 Clean the dispense area.
13 Place the waste bucket back in place. Reinstall the grill in the drip tray and put the drip tray
back in its place.
14 Close the door.
15 Clean the exterior of the machine with a light damp cloth.
To Next Page
Loading...