60
EN
12.2 Repairs
! WARNING
Repairs are understood to be anything for which tools are needed to work on the machine. Those
repairs may only be done by authorized technicians (see also paragraph 3.1). For any repairs only
original parts may be used.
The demands made from a technician are:
1 The technician has to be informed of all laws and regulations regarding electrical connections,
electrical symbols, etc.
2 The technician is very familiar with the machine, by training with Veromatic International B.V.
or similar training obtained elsewhere.
3 The technician uses the instructions, diagrams etc., applicable for this type and model.
4 The technician takes all security precautions for himself and others so as not to be exposed to
any danger, electrical as well as mechanical.
5 The technician is well aware of the applicable guidelines regarding hygiene.
The technician must take the following precautions while working on this machine:
1 Unplug the plug from the wall outlet.
2 Observe all general safety directions (see chapter 1)
3 Check to see if ground connections that have been removed are properly installed and
functioning again. Failing to do so may cause a dangerous situation for both mechanic as
users.
4 Micro-electronics are used in this machine. It is therefore necessary to wear a grounded
bracelet with such service operations. For the same reason, the printed circuit boards that
need to be repaired must be packaged in antistatic packaging material before they are
transported.
To replace parts, use only original (spare) parts, issued by Veromatic International B.V. These satisfy
strict quality demands which assure that the machine continues to function optimally. If original parts
are not used, the warranty is null and void and Veromatic International B.V. is not responsible for
possible damages resulting thereof.
To Next Page
Loading...