Veromatic MBE01 - Service; Safety and Hygiene; Water Lock and Water Filter; Safety Inspection

55
EN
10 Service
10.1 Safety and hygiene
It is important for the safety and hygiene of the machine that it receives a service inspection each year
and optionally parts are replaced. Use only original spare parts of Veromatic International BV.
Take precautions for your personal safety as described in the safety chapter in the beginning of this
manual.
10.2 Water lock and water filter
Veromatic International BV strongly advises to use a water lock (ordering code HL-00190) to prevent
high damages in case of leakages and will accept no responsibility nor liability with regard to water
damage if the vending machine is installed without this protection.
A water filter is advised by Veromatic International BV to:
• keep the in-cup quality consistent
• minimise limescale buildup.
The filter must be replaced after a certain period (given by the supplier of the filter). A too long used
water filter is detrimental to the operation of the machine and can be dangerous to health.
10.3 Safety inspection
• Check all seals for leakage, in special:
− the boiler connections
− the inlet valve
− the outlet valves
• Check all electrical wiring. In special all wiring and connectors which are in connection with the
heating element and replace if necessary.
• Check all hoses for cleanliness and tears and replace if necessary.
• Inspect all relais and replace if necessary.
10.4 Hygiene
For proper hygiene and safety, it is important to check the machine for proper maintenance; is there no
accumulation of product residue in the outlets for example. If the machine is not well maintained, inform
the operator of the risks and, if necessary, give proper instructions.