15
EN
1 Open the lower panel of the door with the hand removable knurled nuts. (/3.4 a)
2 Place the product stickers on the taste card in correspondance with the standard or desired
configuration. (/3.4 b)
3 Insert the taste cards in the slot of the plastic holder (/3.4 c).
4 Close the inner panel with the knurled nuts. (/3.4 d)
3.7.4 Using a customized key layout
1 Close and re-open the door to activate the Rinse menu.
2 Choose the password option and enter the password. (/3.4 e)
3 Change the configuration of the buttons.
4 Exit the menu.
3.8 Start Up
1 Open the front door of the machine.
2 Fill the bean canister with coffee beans.
3 Take the instant product canisters out of the machine with the outlet upwards.
4 Fill the canisters to maximum three quarters of the capacity. Don’t press the contents. See
paragraph 3.7.1 for the type and order of the canisters.
! ATTENTION!
Maximum filling will lead to spillage and cause poor hygiene. Overfilling can prevent proper
functioning of the machine. The products may not be tamped down!
5 Place the canisters back in the machine.
! ATTENTION!
Mind that the outlets are turned downward inside the mixer.
6 Close the door.
7 Turn the machine on by means of the switch on the back of the machine.
8 The airbreak is empty, so will trigger the boiler filling procedure. Follow the instructions on the
display or the following:
9 Place a container (>1 L) underneath both the main outlet and the hot water outlet and press
start.
10 The airbreak and the boiler will fill with water. After that a message ‘Temperature too low’ will
appear on the display.
11 Wait until the water in the boiler reaches the correct temperature. (The message ‘Temperature
too low’ disappears from the screen.)
12 Open the door of the machine to activate the Rinse menu.
13 Rinse all lines of the machine through the Rinse option.
14 Close the machine door.
To Next Page
Loading...