30
EN
10 Rinse the brewer with warm water under the tap. Dry the brewer.
11 Reinstall the inlet hose thoroughly in the quick coupling at the bottom (see 25/26 in reverse)
12 Replace all parts in the reverse order. Check if the drive notch is aligned with the motor shaft
and if the sensor carrier is aligned with the notch on the back of the brewer.
13 Fix the brewer with the pin.
14 Reinstall the waste bucket in the machine.
15 Close the outlet bracket.
16 Close the door.
17 Turn the machine on.
18 Run a brewer cleaning cycle in the Rinse menu:
• Go to
‘Brewer cleaning cycle’.
• Follow the instructions on the display.
• Empty the drip tray and waste bucket when asked.
• Close the door.
• Place a large enough (± 1 L) container underneath the outlet to catch the cleaning liquid
and confirm with Start.
To Next Page
Loading...