Vertiv Liebert EDGE Series User Manual

Vertiv | Liebert® EDGE | Installer/User Guide
21
3.2.4. Settings Submenu
The settings screen consists of tabs that list UPS settings for conguration and adjusting parameters with tabs
for:
• Input
• Output
• Battery
• Monitor
• System
• Prog Outlets
NOTE: Do not change parameter settings or reset to factory defaults when powering-o the UPS.
To modify UPS settings:
1. At the main menu, select the Settings icon, and press Enter.
2. Use the arrow buttons to move the cursor left/right and select a tab, then press Enter to display the
parameter list for the selected tab.
NOTE: Parameter settings are password protected, the detail see Editing Display and Operation Settings on page
33.
Input Parameter Options
Input Waveform sensitivity
Input waveform sensitivity setting.
• High (Default)
• Medium
• Low
Output Parameter Options
Voltage selection
Nominal voltage setting. Set the nominal system voltage to match the input voltage of the UPS
• 200 V
• 208 V
• 220 V
• 230 V (default)
• 240 V

Vertiv Liebert EDGE Series Specifications

General

Brand	Vertiv
Model	Liebert EDGE Series
Category	UPS
Language	English