Operations34
PROMPT MEANING
Start battery manual test?
Appears when execute the command of ‘Start battery manual test’ on the LCD panel
‘Control’ page.
Stop battery manual test?
Appears when execute the command of ‘Stop battery manual test’ on the LCD panel
‘Control’ page.
Clear faults? Appears when execute the command of ‘Clear faults’ on the LCD panel ‘Control’ page.
Reset power statistics?
Appears when execute the command of ‘Reset power statistics’ on the LCD panel
‘Control’ page.
New alarm present Appears when new alarm occurs.
New Fault present Appears when new fault occurs.
3.3.1. Changing the Password
The default password is 111111 (six ones). You must use the current password to change the password.
1. At the main menu, select the Settings icon, and press Enter.
2. At the password prompt, use the up-arrow to select the rst digit, press the down-arrow to move to the next
digit, repeat for each digit, then press Enter to access the settings.
3. Use the arrow buttons to select the Monitor tab, then press Enter.
4. Use the down arrow to highlight Change Settings Password, press Enter, and re-enter the current password.
The Input new password dialog opens, see below.
5. Enter the new password, then conrm the new password. A conrmation dialog opens to indicate a
successful password change.
6. Press ESC to return to the settings or main menu.
Figure 3-2 New and Confirm Password dialogs
To Next Page
Loading...
Need help?
General