Operations32
Product Information
Product Typ e
UPS model name.
Serial number
UPS serial number.
Time since startup
Elapsed time since start-up of the UPS.
UPS FW version
Version of UPS rmware on the control board.
Communication FW version
Version of communication rmware on the communication board.
LCD module FW version
Version of LCD module rmware on the display panel.
Network
MAC address
Shows the MAC address of the SNMP card. This is only shown when the SNMP card is installed.
IPv4 address
Shows the IPv4 address of the SNMP card. This is only shown when the SNMP card is installed.
3.2.8. Maintenance screen
The Maintenance screen oers operation of restore factory default.
To restore factory default:
1. At the main menu, select the Maintenance icon, and press Enter.
2. Use the arrow buttons to move the cursor to the option, then press Enter to select the control.
Note : The operation is password protected. The password is 12345.
Restore factory default
If the operation success, it will restore conguration to factory defaults.
To Next Page
Loading...
Need help?
General