Vertiv Netsure - EEM Protocol Configuration

NetSure
™
Control Unit (NCU)
User Manual, UM1M830BNA
Spec. No: 1M830BNA, 1M830DNA Code: UM1M830BNA
Model No: M830B, M830D Revision M, May 12, 2017
[173]
EEM Protocol
You can set EEM protocol parameters.
Figure 105. EEM Protocol
 Protocol Type: Select EEM, RSOC, or SOC/TPE per site requirements.
 Protocol Media: Select RS-232, Modem, IPV4, or IPV6 per site requirements.
 Port Parameter: Enter the port parameters per site requirements.
 Callback Enabled: Select per site requirements.
 Report Enabled: Select per site requirements.
 CCID: Enter value per site requirements.
 Maximum Alarm Report Attempts: Enter value per site requirements.
 Call Elapse Time: Enter value per site requirements.
 Safety Level: Select per site requirements.