Fuel lter assembly4.8
Make sure that the ignition key is in the OFF position then, discon-
nect the battery terminal (-) .
Disconnect the rapid connectors from the fuel lter, fuel lter
side.
Unscrew the fuel lter from the bracket.
Raise the fuel lter assembly (3 a) by the required amount and
disconnect the electrical connection (3b) from the water presence
sensor, then remove.
Working at the bench, unscrew the water presence sensor in the
fuel lter and remove.
Ret the water sensor in its seat on the fuel lter.
Connect the electrical connection to the water presence sensor,
then ret the fuel lter assembly in its seat.
To screw the lter in its seat of the bracket.
Connect the rapid connectors for the fuel pipes, fuel lter side.
Connect the negative battery terminal (-).
To Next Page
Loading...
