VIA694X System Board 34
Second Boot Device
This category determines which drive the system searches first. System will
search in turn for floppy disk drive; then hard disk drive, and finally Floppy drive.
Default value is “HDD-0”. Options are as below:
FLOPPY; LS120; HDD-0; SCSI; CDROM; HDD-1; HDD-2; HDD-3;
ZIP100; LAN; Disabled
Third Boot Device
This category determines which drive the system searches first. System will
search in turn for floppy disk drive; then hard disk drive, and finally Floppy drive.
Default value is “LS120”. Options are as below:
FLOPPY; LS120; HDD-0; SCSI; CDROM; HDD-1; HDD-2; HDD-3;
ZIP100; LAN; Disable
Boot other Device
:Enabled (default)
:Disabled
Swap Floppy Drive
Enabled: floppy A&B will be swapped.
Disabled(default): floppy A&B will not be swapped.
Boot Up Floppy Seek
BIOS will determine if the floppy disk drive is 40 or 80 tracks. 360k type is 40
tracks while 720K/1.2M and 1.44M are all 80 tracks. Default value is Disabled.
Boot Up Numlock Status
:On(default)
:Off
Gate A20 Speed
:Normal
:Fast(default)
To Next Page
Loading...
