10
Safety
Only connect the hydraulics when the system is depressurised
You should only connect the hydraulic hoses to the tractor's hydraulics
when the hydraulic system on both the tractor and the machine is
depressurised.
There is a risk that the machine will move accidentally.
Accidental movement of the machine can result in serious injury.
The hydraulic system should be checked regularly
All hoses and fittings should be checked regularly for visible damage.
Hydraulic hoses also wear without any visible damage.
Defective hydraulic hoses can cause injury or fire.
Colour marking of the hydraulic connections
The hydraulic connections between the tractor and the machine must
be colour marked.
By colour marking the hydraulic connections you avoid wrong
operation of the machine.
Wrong operation or unintentional movements of the machine can
result in serious injuries.
Load capacity
Compliance with total weight, axle pressure, carrying capacity of
the tyres, and minimum weight
Neither the tractors total weight, axle pressure or the carrying capacity
of the tyres may be exceeded with front mounted and rear mounted
machines.
The front shaft should be loaded with at least 20 % of the tractor dead
weight to secure a stable manoeuvring.
Transgression can result in uncontrolled driving and accidents.
Be careful when working around the PTO shaft
When working on the PTO shaft, the tractor PTO outlet must be
disconnected, the tractor must be stopped and the ignition key
removed.
This prevents the PTO shaft from suddenly starting to rotate.
If the tractor and the PTO shaft have not been connected following the
instructions serious accidents causing damage to limbs can occur.
Weight/power ratio between machine and tractor
The machine may only be connected to a tractor with a proper size
and performance.
The tractor's size and P.T.O outlet must correspond to the power
consumption of the machine and its weight.
Wrong weight/power ratio can result in damage to both machine and
tractor.
95-009
kg
HP/kW
To Next Page
Loading...
