52
Maintenance
General
instructions
These instructions concern general maintenance work. Specific
maintenance work procedures for each machine will be described
later. When performing all maintenance work the machine must be
secured in the transport position. If the working position is necessary
for performing maintenance work, you will find appropriate instructions
concerning this work.
T
IP
Working with grease gun
Lubrication is performed by one or two pumps with the grease gun. If
you feel resistance after just one pump with the grease gun do not
apply more grease to the bearings. Too much grease bearings drift
apart. In this case dust and dirt can enter the bearings and cause an
early wear and tear.
Basic
This table contains explanations of the most important terms related
to maintenance.
Work Performance
Lubricating with oil can Add oil from the can to the moving parts. Use only authorised products.
»Technical information« page 94
Lubricating with
grease gun
1-2 pumps with the grease gun is sufficient unless otherwise stated. Use only
authorised products.
»Technical information« page 94
Oil change Use only authorised oil products. Using used oil is dangerous for your health and is
strictly prohibited.
»Technical information« page 94
Replace Replace the appropriate part following the instructions given in the "Replacement"
chapter
»Replacement« page 71
Check Check the appropriate part following the instructions given in the "Service - check"
chapter
The check is sometimes related to the replacement of the part in question
»Service - check« page 57
Complying with the
maintenance intervals
All specifications are based on an average usage of the machine. If heavily loaded, e.g.
contractor, the maintenance intervals should be performed on a more regular basis. In
work conditions producing high levels of dust, maintenance should also be carried out
on a more regular basis
To Next Page
Loading...
