Operation
48
Operation
Safety
The operator should receive careful instructions before using the
machine
The machine should only be used if the operator has been given
thorough instructions.
Thorough machine instruction allows safe usage.
Insufficient training may lead to incorrect usage of the machine and
accidents.
The side guard for the cutting unit must be correctly positioned
before start up
The side guard for the cutting unit must be folded out and correctly
positioned before the machine is started.
This ensures that the machine will give maximum protection to the
operator.
Moving objects may cause serious injuries and accidents.
The machine is operated in the following way:
Make sure that there are no persons in the surrounding area.
Fasten all the guards on the machine.
Check that the side guard on the cutting unit is folded out and
correctly positioned.
Position the tractor and the machine in a straight line.
Check that the mechanical safety valve is open.
Carefully connect the tractor's PTO shaft.
Carefully increase the speed of the PTO shaft to 540/1000 RPM.
→ »RPM on the PTO outlet« page 26
Use the tractor's machine handle to operate the hydraulic
functions.
If none of the machine's functions are working:
Stop the tractor’s forward drive.
Stop the tractor.
Disconnect the PTO shaft immediately.
If the machine is too noisy or vibrates too much, stop the machine
immediately.
→ »Troubleshooting« page 128.
To Next Page
Loading...
