VICTOR TECHNOLOGY
66
300
300.00
Displays the initial debt of $300
R/S
203.00
Executes the program and displays the amount owed
after 1 month of interest at 1% and a $100 payment.
105.03
After a pause, displays the amount owed after the 2
nd
month
6.08
After a pause, displays the amount owed after the next
month
-93.86
After a pause, displays the amount owed after the next
month. In this case, a $100 payment would create a
balance less than zero and the program stops.
Note: With this example, if the program is halted before completion, the
registers must be cleared by pressing b REG before running the program
again.
Note: With this example, an initial debt of more than $10,000 will result in a
growing credit card debt despite the $100 monthly payment.
Storing More Than One Program
More than one program may be created and stored if each program ends with
1) the R/S instruction to halt execution at program end and 2) the GTO
instruction looping the program back to the starting line if it is to run again. To
run a program that starts at a line other than 001, set the calculator to the first
line in the program with a GTO instruction before you touch R/S.
To Next Page
Loading...
Need help?
General
