30
Setting the time program for DHW heating
Note
You can only adjust the time program
for DHW heating if a DHW cylinder is
connected to the central heating boiler.
In the time program, a day is divided
into one-hour time phases. For each
time phase you can select whether
DHW heating should be on or off.
Setting a day program
Press the following buttons:
1. OK+ simultaneously for longer
than 5 seconds.
2. MODE to confirm
3. / for switching DHW heating
on/off in the 1-hour time
phase.
Note
Display
■ e.g. "50 °C" (preset DHW
temperature):
DHW heating is switched
on.
■ "OFF":
DHW heating is switched
off.
4. OK to confirm. The next phase
is displayed. The previously
selected value is automati-
cally adopted.
5. Repeat steps 3 and 4 for
the full 24 hours.
Note
Any changes that are not confirmed
with OK are not adopted.
Terminating or prematurely cancel-
ling the setting of time phases
1. MODE repeatedly until the required
display appears.
DHW heating
Time program
(cont.)
5837147
To Next Page
Loading...
