ViewSonic SC-T45 - Discovering Clients Using a Predefined IP Range List

Using ViewSonic Device Manager
Adding Clients into a Managed Group
45
3.3.7 Discovering Clients using a Predened IP Range List
To discover unmanaged clients using a predefined IP Range list and add the desired client(s) into a managed group
under ViewSonic Device Manager, please do the following:
NOTE
• If you haven’t create any IP Range list, please refer to “3.3.6 Creating and Managing
an IP Range List” on page 44 for instructions.
1. On Scan tab, click to check Scan by List of IP Ranges.
2. The IP Range list appears.
3. Click to select the desired IP range, and then click Scan to look for unmanaged clients within the range.
4. While searching for thin clients, the selected IP range is shown on the right.
5. On completion, the discovered clients are listed in Management area.