© 2010 Viking Preferred Service
60
Service Diagnostics and Procedures
Freezer Door and Rail Assembly
1. Remove upper bins (see upper bin removal
section, page 59).
2. Press release clips inward on left and right glide
adapters.
3. Pull door, drawer slides, lower bins, upper and
lower glide assemblies forward to remove.
4. Reverse procedure to reinstall.
Glide Adapter
1. Remove upper bins (see supper bin section,
page 59).
2. Remove freezer door and rail assembly
(see freezer door and rail assembly section
at left).
3. Remove securing screws and left and right glide
adapters.
4. Reverse procedure to reinstall.
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Service Diagnostics and Procedures–Disassembly
Tab
Tab
Screw
Screw
To Next Page
Loading...
