VIMTAG IP VT 361 SECURITY CAMERA
Page
21
• If there is a red circle to the left of the camera name, it means that the
camera is offline and is not accessible from a remote location.
• If you are unable to confirm that the camera is working, see
Troubleshooting for the Camera.
Wrench
The Wrench icon will allow you to remove certain cameras that you have
set up in your account. When you click the Wrench icon, all the cameras in
the list will now have a red circle with a white minus sign through it.
• To remove a camera, click its red circle.
• To refresh the list and remove all red circles, click the plus sign icon.
Note: Be careful with this setting, so you do not delete any cameras by
mistake! If you do, you can
add cameras with the plus sign icon.
Plus Sign
To add another camera to your account, click the plus icon, located just to
the right of the Wrench icon. When you click the icon, a popup will appear
in the center of the screen. In that popup screen, you will be able to add
the input device ID of the new camera. Add the ID and follow the screen
prompts to add the new camera to your list.
Refresh Arrow
The refresh arrow will refresh the list of cameras on the left side of your
screen.
Hide
To streamline your screen and hid the camera list, click the icon located
just below the bar of three icons. Click the icon again to display the camera
list.
To Next Page
Loading...
