VIMTAG IP VT 361 SECURITY CAMERA
Page
29
When you format, the camera will go offline for a minute, and then it
will come back online and be ready to use.
Note: Every time you format the card, all of the content will be erased. If
you have content that you need to save, make sure you save it off the
card before formatting.
• Unmount is an option to disable the ability to record onto the SD card
without having to remove the card. You will have the option to mount
a dismounted card. Click Apply to save the setting.
Storage Device
Using the Storage Device option, you can introduce another element of the
Vimtag solution, the Cloud Box. The Vimtag Cloud Box is an ideal DIY (Do It
Yourself) security solution for homes and small businesses that require the
recording of many hours of continuous video. To use a Cloud Box, you must
first connect the Cloud Box to the same network where the VT-361 is
connected. Once you have confirmed that the Cloud Box is connected, you
need to enter the Cloud Box ID and password and enable its use in the
Storage Device tab. For more information on the Cloud Box, see the Vimtag
Cloud Box documentation.
Motion and Notification
The VT-361 can detect motion in the area covered by the camera and can,
as a result of that detection, take a snapshot, record a video, etc.
The Motion and Notification tab offers two options to configure what the
VT-361 should do if and when motion is detected in the covered area:
• Motion Detection
• I/O Alarm
To Next Page
Loading...
