VIPA System 300S SPEED7 CPU 313SC/DPM - Chapter 4 Deployment CPU 313 SC;DPM

Manual VIPA System 300S SPEED7 Chapter 4 Deployment CPU 313SC/DPM
HB140E - CPU SC - RE_313-6CF03 - Rev. 07/45 4-1
Chapter 4 Deployment CPU 313SC/DPM
This chapter describes the deployment of the CPU 313SC/DPM with
SPEED7 technology in the System 300. The description refers directly to
the CPU and to the employment in connection with peripheral modules that
are mounted on a profile rail together with the CPU at standard bus.
Topic Page
Chapter 4
Deployment CPU 313SC/DPM ........................................4-1
Installation............................................................................................ 4-2
Start-up behavior.................................................................................. 4-3
Addressing ........................................................................................... 4-4
Address assignment............................................................................. 4-6
Initialization Ethernet PG/OP channel .................................................. 4-7
Access to the internal web page......................................................... 4-10
Project engineering as CPU 313C-2DP.............................................. 4-11
CPU parameterization ........................................................................ 4-14
Parameterization of the RS 485 interface X3 ..................................... 4-18
Parameterization of modules.............................................................. 4-21
Project transfer................................................................................... 4-22
Operating modes................................................................................ 4-26
Overall reset....................................................................................... 4-29
Firmware update ................................................................................ 4-31
Factory reset ...................................................................................... 4-35
Memory extension with MCC.............................................................. 4-36
Extended know-how protection........................................................... 4-37
MMC-Cmd - Auto commands ............................................................. 4-39
VIPA specific diagnostic entries ......................................................... 4-41
Using test functions for control and monitoring of variables................ 4-45
Overview
Content