INSTRUCTION FOR USE ENGLISH
11
OPERATING GUIDE
WARNING!
On some points of the machine there are some adhesive plates indicating:
－ DANGER!
－ WARNING!
－ CAUTION!
－ CONSULTATION
While reading this Manual, the operator must pay attention to the symbols shown on the plates. Do not
cover these plates for any reason and immediately replace them if damaged.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either
improperly installed or connected. The batteries must be installed by qualified personnel
only. Set the function of the electronic board and the built-in battery charger according to
the type of batteries used (WET or GEL/AGM batteries). Check the batteries for damage
before installation. Disconnect the battery connector and the battery charger plug. Handle
the batteries with great care. Install the battery terminal protection caps supplied with the
machine.
NOTE
The machine requires two 12 V batteries, connected according to the diagram (Figure3).
To Next Page
