9
WORKING MODE DESCRIPTION
Key (42) on
One button start (49)on
1: Hour meter point does not flash.
2: The brush arrow does not rotate.
3: The fan does not flash.
4: The tap water does not flash.
5: The actuator puts down to the first level pressure.
Key (42) on
One button start (49)on
Safety switch(35)on
1: Hour meter point flashes.
2: The brush arrow rotates.
3: The fan flashes. (Four blades）
4: The tap water flashes.
Key (42) on
One button start (49) on
1: Hour meter point does not flash.
2: The brush arrow does not rotate.
3: The fan does not flash.
4: The tap water does not flash.
Key (42) on
One button start (49) on
Press vacuum system adjustment
button (50) on for 1 second
Safety switch (35) on
1: Hour meter point flashes.
2: The brush arrow rotates.
3: The fan flashes. (Three blades）
4: The tap water flashes.
Safety switch (35) off
One button start (49) off
Key (42) on
1：Hour meter point does not flash .
2：All panel button closure.
（The vacuum motor delays 12 seconds to stop .)
3：The brush head puts up to the highest position.
1. The power cut off.
2. The display is off.
Note: After turning off the one button start (49),
wait until the brush head raises to the full up posi-
tion, before turning off the key (42).
To Next Page
Loading...
Need help?
General
