INSTALLATION NOTICE
The conditions and tests required for TSO approval of this article are
minimum performance standards. It is the responsibility of those
installing this article either on or within a specific type or class of aircraft
to determine that the aircraft installation conditions are within the TSO
standards. TSO articles must have separate approval for installation in
an aircraft. The article may be installed only if performed under 14CFR
part 43 or the applicable airworthiness requirements.
PURCHASER / USER AGREEMENT
The purchaser and/or user, by accepting this equipment, agrees to hold
VISION MICROSYSTEMS INCORPORATED, its owners, assigns,
heirs and employees, free and harmless from all loss, liability or
damage resulting from claims brought by any reason of alleged failure
or defect of any parts supplied by
VISION MICROSYSTEMS INCORPORATED.
VISION MICROSYSTEMS INCORPORATED has made every effort to
document this product accurately and completely. However, VISION
MICROSYSTEMS INCORPORATED assumes no liability for errors or
for damages that result from the use of this manual or the equipment it
accompanies. VISION MICROSYSTEMS INCORPORATED reserves
the right to make changes to this manual and the product at any time
without notice.
****** TO RECEIVE WARRANTEE COVERAGE *******
FILL OUT AND RETURN THE WARRANTEE AGREEMENT.
VISION MICROSYSTEMS INCORPORATED
4255 Mitchell Way
BELLINGHAM, WASHINGTON 98226
PHONE (360) 714-8203 FAX (360) 714-8253
www.visionmicrosystems.com
ADVANCED ELECTRONIC INSTRUMENTATION
To Next Page
Need help?
General