SECTION 1: INSTALLATION 9
EPI800 Manual.doc EPI 800 MANUAL 2001 Vision Microsystems Inc.
1.10 CYLINDER HEAD TEMP PROBE INST.
Install the probe assemblies in the tapped holes located on the
underside of the cylinders. The threads in the holes may require
cleaning. Proceed carefully to prevent damaging the threads.
Route wires away from exhaust stacks and other heat sources with
enough slack to allow for engine vibration, etc. Do not route the leads
creating stress where they exit the probe. A gradual radius away from
the probe is best.
After installation is completed, connect the probe utilizing the white and
red color-coded thermocouple extension wire and terminals as shown in
‘APPENDIX C: DPU P2 Connector Harness Fabrication’.
IMPORTANT NOTES:
Probe shorter lead is RED, and the longer is WHITE.
Extension wire may be cut to desired length.
To Next Page
Loading...
Need help?
General