SECTION 2: OPERATION 25
EPI800 Manual.doc EPI 800 MANUAL 2001 Vision Microsystems Inc.
2.7 ADDING FUEL TO THE FUEL COMPUTER
***************************** WARNING *********************************
IMPROPER USE OF THIS FEATURE WILL GIVE YOU INCORRECT
FUEL 'TOT' AND ‘HRS’ INFORMATION. INSURE THAT YOU
UNDERSTAND THE OPERATION OF THIS SYSTEM BEFORE
USING IT INFLIGHT. AFTER INSTALLATION AND PERIODICALLY
THEREAFTER, VERIFY THAT THE SYSTEMS ACCURACY IS
ACCEPTABLE FOR YOUR INTENDED USE.
****************************************************************************
Your fuel computer has a unique feature that allows you to 'ADD' fuel
according to how much has been pumped into the tank(s). You are not
required to calculate the new total fuel level after adding fuel, as on
many other fuel computers. This system does it for you. Follow the
steps below to 'ADD' fuel to the computer:
STEP 1. Place the MODE switch in the 'ADD' position and wait until
the digital display shows the fuel pumped into the tank. (If the
pump showed an uneven amount such as 17.8, then go to
the next gallon higher (18.0) and select 'SUB' and wait until
the display counts down to the pumped amount.) If you want
to start over, select 'CLR' which clears the display.
STEP 2. When the display shows the amount of fuel pumped into the
tank(s), quickly move the selector to the 'OK' position. The
display will show 'AddEd'.
STEP 3. Wait for this message to disappear and 'rdy' to appear. The
fuel has now been added to the existing computer memory
total. Select any other normal mode of operation.
NOTE: To top off the computers tank, just leave the mode switch in
'ADD' until the display stops counting up which signifies the full tank
size has been reached, then proceed from STEP 2.
To Next Page
Loading...
Need help?
General