SECTION 2: OPERATION 33
EPI800 Manual.doc EPI 800 MANUAL 2001 Vision Microsystems Inc.
SETTING LOCAL TIME:
STEP 1. With power on, place the selector switch in the 'straight up'
position (between the 'RUN' and 'STOP' positions). The
display should go blank.
STEP 2. Turn the power off for a few seconds, then back on. The
display will now alternately show 'Utc ?' and 'Loc ?'.
STEP 3. When the display shows 'Loc ?', move the selector switch to
the 'HRS' position. When the hours value gets to the correct
hour, move the switch to the 'straight up' position as before.
The display will read 'Locrdy'. Wait for this message to
disappear, then move the selector to any desired position.
(You can now check 'LOC' for the correct local time). NOTE:
Since universal and local minutes and seconds are the
same, you can only set local hours.
To Next Page
Loading...