vision microsystems EPI 800

To Next Page

To Previous Page

SECTION 4: INSTALLATION REFERENCE 45

EPI800 Manual.doc EPI 800 MANUAL 2001 Vision Microsystems Inc.

FIGURE 2: C.A.T. PROBE MOUNTING

Main Page

Table of Contents5
Dpu, Switch, Display Cable Installation9
- DPU Mounting9
- Wiring of DPU Harness Connectors P1 and P29
- Wiring of DPU Display Cable Harness9
Indicator Mounting and Connection10
Mode Switch Installation11
Rpm Transducer Installation12
Manifold Pres. Transducer Inst13
Oil Temperature Transducer Inst14
Oil Pressure Transducer Inst14
Fuel Flow Transducer Inst15
Fuel Pres. Transducer Inst16
Cylinder Head Temp Probe Inst17
Exhaust Gas Temp Probe Inst18
Voltage Sense Wire Inst19
Amp Transducer Inst19
Transducer Inst20
Io Interface Board Inst21
Fuel Level Mounting Kit Inst23
Fuel Probe Inst25
Initial System Set-Up26
Tachometer Operation27
Manifold Pressure Operation28
Oil System Operation29
Fuel Computer System Operation31
Initial Set up of the Fuel Computer32
Adding Fuel to the Fuel Computer33
Fuel Computer Normal Operation Modes34
Cylinder Analyzer System Operation35
Leaning Your Engine36
Electrical Monitoring System Operation37
Air Temperature System Operation38
Chronometer System Operation39
Initial Chronometer Set up40
Chronometer Modes42
Io Interface Board Operation44
Fuel Level System Operation45
Fuel Level System Calibration45
Indicator Care and Maintenance47
Transducer Care and Maintenance48
Data Processor Care and Maintenance48
Customer Service49
Installation Reference51
Reference Information: Figure 1: Epi 800 Ind. & Switch Mounting52
APPENDIX A: Transducer Connector Wiring Techniques61
APPENDIX B: DPU P1 Connector Harness Fabrication63
APPENDIX C: DPU P2 Connector Harness Fabrication66
APPENDIX D: Display Cable Fabrication68
APPENDIX E: IO Interface Board J2 Wiring72
APPENDIX F: System Block Diagram73
APPENDIX G: Recommended Tools74
APPENDIX H: Fuel Level System Calibration Chart75
APPENDIX I: Specifications & Operating Conditions78
APPENDIX J: Troubleshooting Guide79

vision microsystems EPI 800 - Page 53

Table of Contents