vision microsystems EPI 800 - Page 7

TABLE OF CONTENTS
EPI800 Manual.doc EPI 800 MANUAL 2001 Vision Microsystems Inc.
3.4 CUSTOMER SERVICE ......................................................... 41
4.1 INSTALLATION REFERENCE ............................................. 43
REFERENCE INFORMATION:
FIGURE 1: EPI 800 IND. & SWITCH MOUNTING ............................... 44
FIGURE 2: C.A.T. PROBE MOUNTING .............................................. 45
FIGURE 3: DPU MOUNTING................................................................ 46
FIGURE 4: FUEL PROBE INST. DRAWING ........................................ 47
FIGURE 5: DPU P1 Cable Preparation ............................................... 48
FIGURE 6: RPM Transducer Placement ............................................ 50
FIGURE 7: Fuel Flow Transducer Orientation .................................. 51
FIGURE 8: Amps Transducer Orientation ......................................... 52
FIGURE 9: Display Cable Shield Installation .................................... 62
APPENDIX A: Transducer Connector Wiring Techniques ............... 53
APPENDIX B: DPU P1 Connector Harness Fabrication ................... 55
APPENDIX C: DPU P2 Connector Harness Fabrication ................... 58
APPENDIX D: Display Cable Fabrication ........................................... 60
APPENDIX E: IO Interface Board J2 Wiring ...................................... 64
APPENDIX F: System Block Diagram ................................................ 65
APPENDIX G: Recommended Tools .................................................. 66
APPENDIX H: Fuel Level System Calibration Chart ......................... 67
APPENDIX I: Specifications & Operating Conditions ...................... 70
APPENDIX J: Troubleshooting Guide ............................................... 71
TABLE 1: DPU Harness P1 Connector Wiring .................................. 57
TABLE 2: DPU Harness P2 Connector Wiring .................................. 59