E4100 SYSTEM TAB
Reboot – This button reboots the unit.
Factory Default – This button factory defaults the unit. See section Troubleshooting.
Change Password – This button changes the unit’s web interface login password to values entered below (default is admin).
• Password – enter new password
• Reenter Password – reenter new password
Important: Make sure you write the new password down. If it is lost or forgotten, you will need to call Visionary Solutions
support to assist in a console factory default of the unit.
Set update file – Browse to a new firmware file supplied by Visionary Solutions or downloaded from visionary-av.com.
Update Unit – This button will initiate a firmware update per the specified file above.
Information – Real-time status messages displayed during a reboot, firmware update, or factory default action.
To Next Page
Loading...
