D4100 DECODER CONFIGURATION TAB
STREAM.HOST – See section Configuring Stream Settings (Manually).
STREAM.MODE – Unicast or multicast. See section Configuring Encoder and Decoder IP Addresses.
STREAM.AUDIO – Select the source of audio for the AV over IP stream - HDMI. See section Audio Settings.
AUDIO.VOLUME – See section Configuring Stream Settings (Manually).
AUDIO.MUTE – Used to mute or unmute AV stream audio. Is a boot parameter, unit must be rebooted for change to be applied. See
section Configuring Stream Settings (Manually).
To Next Page
