Vislink UltraReceiver LD User Manual

UltraReceiver LD User Manual
Specification
Issue No: 2.01 Page: 11
Ref: ULRXLD-ASUM-700X Copyright © 2020 Vislink Technologies, Inc.
3.12.6. CTRL/Data
Chassis Socket Connector:
LEMO EEF0B306CLV
Mating Cable Plug:
LEMO FGF0B306CLAD52Z
LEMO Pin
Function
Pin 1
Tx Data (output)
Pin 2
Rx Data (input)
Pin 3
0v
Pin 4
Tx Control (output)
Pin 5
Rx Control (input)
Pin 6
0v
Table 3-1 CTRL/Data Pinout Information
The serial data from the camera is returned via the transmitter as part of the
MPEG transport stream in a similar way as the RS232 ‘User data’. It is then
extracted from the transport stream by the decoder and passed back to the Data
transmitter, via this Camera Control connector (‘Camera Return Data Tx’).
3.12.7. Audio 1
Audio 1 consists of two three-way XLR Male Chassis mounted plugs. See Table
3-2.
XLR Connector
Function - Analogue
Pin 1
Audio Ground
Pin 2
+ve
Pin 3
-ve
Table 3-2 Audio 1 Pin Out
CAUTION: Attaching any audio inputs with phantom power applied may damage
the audio output amplifiers. The unit uses internal protection on the
audio outputs, but damage may still occur. The unit warranty does not
cover any damage caused through the audio outputs.
Analogue Mode:
 48kHz sampling
 Clip level 18dB
 THD < 0.1%
 20Hz to 18kHz ±0.25dB
 Crosstalk >60dB minimum
 Signal to noise ratio >66dB RMS
3.12.8. Audio 2
Not used.

Vislink UltraReceiver LD Specifications

General

Brand	Vislink
Model	UltraReceiver LD
Category	Receiver
Language	English