UltraReceiver LD User Manual
Main Display
Issue No: 2.01 Page: 18
Ref: ULRXLD-ASUM-700X Copyright © 2020 Vislink Technologies, Inc.
5.2.6. Genlock
Genlock controls the mode of operation for video synchronization.
OFF, uses the Transport stream PCR to maintain timing.
ON (external) uses tri-level or composite sync to provide the timing reference.
NOTE: Using ON (external) adds 40ms delay to the system (internal or external).
ON (internal) references the video to an internal oscillator.
When ON, the line & pixel offsets are adjustable.
The line number is adjustable between 0 and 1124. For negative offsets use
values between 0 and 540, for positive offsets use the formula, 1124 minus the
offset required as the front panel value. Pixel offset range is 0 to 2749.
NOTE: Line & Pixel ranges may vary with different video formats.
5.2.7. ASI Output
75Ω mini BNC chassis mounted socket.
ASI out source from the Demodulator, Diversity or Ext ASI input for decoding by
an external decoder or chaining to another ULRX-LD.
5.2.8. User Data
User data format output:
Link
Gigawave (requires manual setting for User data rate)
Onboards
Set required User Data PID.
5.2.9. HEVC Dual Decoder
When HEVC dual HD is set, Decoder 1 & Decode 2 options are available.
Common settings to Decoder 1 & 2:
Video Loss
Service Selection
Genlock Mode
Decoder 1 Outputs:
Video 1
Video 3
Decoder 2 Outputs:
Video 2
Video 4
NOTE: Analogue Audio 1 XLR connections are only rooted from Decoder 1.
To Next Page
Loading...
Need help?
General
