76
ВАРШ.201219.009РЭ
The Session Initiation Protocol (SIP) is a signaling communications protocol, widely used
for controlling multimedia communication sessions such as voice and video calls over Internet Pro-
tocol (IP) networks. This page allows user to configure SIP related parameters. Cameras can be
configured as SIP endpoint to call out when alarm triggered; or allow permitted number to call in to
check the video if the video IP phone is used. There are two ways to get video through SIP, one is
to dial the IP address directly, the other is account registration mode, the details are as follows:
Прямой режим IP:
IP Direct mode
Dial on the camera’s IP address directly through SIP phone, so you can see the video.
(Note: SIP phone and the camera should in the same network segment).
Account registration mode
1) Before using the SIP, you need to register an account for the camera from the SIP server;
2) Register another user account for the SIP device from the same SIP server;
3) Call the camera User ID from the SIP device, you will get the video on the SIP device.
The SIP tab is shown in Figure B.17.
To Next Page
Loading...