Vitec Multimedia MGW Ace - Retrieving or Setting Network Parameters through a USB Thumb Drive

MGW Ace Encoder HEVC Encoding and Streaming Appliance
User Manual, Version 2.1 19
Retrieving or Setting Network Parameters through a USB
Thumb Drive
To Retrieve Your Network Parameters through a USB Thumb Drive (When MGW Ace Encoder IP Address
is Unknown):
1. Turn MGW Ace Encoder OFF.
2. Allocate a USB thumb drive, ensure it is empty of any other files and insert it to MGW Ace
Encoder USB port.
NOTE:
USB thumb drive with FAT32 file system must be used.
3. Connect the network cable to MGW Ace Encoder Ethernet port.
4. Turn MGW Ace Encoder ON. The network setup file "EncoderNetworkSettings.txt" is
being copied from the appliance to the thumb drive. Wait a few minutes to ensure that the
file is being copied properly.
5. Remove the USB Thumb drive from the appliance, and insert it to a PC.
6. Open the "EncoderNetworkSettings.txt" file in the USB thumb drive using any text
editor program.
7. Read the IP address from the file.
8. Enter the read IP address in the Internet browser URL field. The Log on window appears.
9. Log in.