VITRIKO
Mobile Data Experts
5. R O U T E R DESIGN
5.7 Removing from the DIN rail
Default position of CPD2 holder (or CKD2 holder for SL v e r s i o n ) , which is used fo r mount-
ing the router on a DIN rail, is shown in the foll owing figure:
Figure 18: Default position of DIN holder
F o r r e movi ng from the DIN rail it is necessary to lightly push upward the router so that the
top part of the CPD2 holder (or CKD2 for SL v e r s i o n ) hitched to the DIN rail get out of this rail
and then fold out the to p part of the router a w a y from the DIN rail.
Figure 19: R e m o v i n g from the DIN rail
11
Contact www.vitriko.com info@vitriko.com
To Next Page
Loading...