VITRIKO
Mobile Data Experts
5. R O U T E R DESIGN
5.8.1 Status indication
About router status inform eight led indicators on the front panel and on e v e r y port are two
LED indicators, which inform about port status.
Caption Color State Description
PWR Green Blinking
On
F a s t blinking
R o u t e r is read y
Starting of the router
Updating firmware
D A T R e d Blinking Communication in progress on radio channel
W A N Y e l l o w 1x flash per second
2x flash per second
3x flash per second
Signal strength is from –50 dBm to –69 dBm
Signal strength is from –70 dBm to –89 dBm or differ-
ence between neighbours cells is e x a c t l y 3 dBm
Signal strength is from –90 dBm to –113 dBm or differ-
ence between neighbours cells is smaller than 3 dBm
USR Y e l l o w F u n c t i o n selected b y user
OUT Green On Binary output active
IN Green On Binary input active
ETH Green On
Off
Selected 100 Mbit/s
Selected 10 Mbit/s
ETH Y e l l o w On
Blinking
Off
The network cable is connected
Data transmission
The network cable is not connected
PORT Green Depends on the e x p a n s i o n port (see user’s guide of used port)
PORT Y e l l o w Depends on the e x p a n s i o n port (see user’s guide of used port)
SIM1 Y e l l o w On SIM card 1 is active
SIM2 Y e l l o w On SIM card 2 is active
T a b l e 6: R o u t e r status indication
State indication of W A N LED is updated e v e r y 10 seconds.
13
Contact www.vitriko.com info@vitriko.com
To Next Page
Loading...