VITRIKO
Mobile Data Experts
6. FIRST USE
6.2 Start
The router is set up connecting the power supply to the router. In the default setting
the router starts to login automatically to the preset APN. Device on the Ethernet port DHCP
server will assign addresses. The behavior of the router can be modified b y means of the w e b
or T e l n e t interface, which is described in the configuration manual.
The power consumption during rece i vi ng is 2,3 W . The peak power consumption during
data sending is 5,5 W . However, v a l u e s of consumption can be increased, if some e x p a n s i o n
port is eqquipped. F o r correct operation it is necessary that the power source is able to supply
a peak current of 1 A.
6.3 Configuration
A t t e n t i o n ! If the SIM card is not inserted in the router, then it is impossible to operate. The
inserted SIM card must have activated L T E / H S P A + / U M T S / E D G E / G P R S .
6.3.1 Configuration o v e r web browser
Monitoring of the status, configuration and administration of the router can be performed
b y means of the w e b interface, which is a v a i l a b l e after insertion of IP address of the router
into the w e b browser. The default IP address of the router is 192.168.1.1. Configuration may
be performed only b y the user "root" with initial password "root".
A detailed description of the router settings via the W e b interface can be found in the con-
figuration manual.
6.3.2 Configuration o v e r T e l n e t
Monitoring of status, configuration and administration of the router can be performed
b y means of the T e l n e t interface. After IP address entry to the T e l n e t interface it is possi-
ble t o configure the router b y the help of commands. The default IP address of the router
is 192.168.1.1. Configuration may be performed only b y the user "root" with initial password
"root".
A detailed description of the router settings via the T e l n e t interface can be found in the con-
figuration manual.
24
Contact www.vitriko.com info@vitriko.com